|
|
|
|
|
This week we will be discussing the “Law of Ohms” or "Ohms Law"…whatever you feel like calling it. It's pretty straightforward stuff and, seeing as I’m a guitar player, I prefer to keep things simple…real simple! So, let's learn by looking at an example of “Ohms Law” at work. First though, let's remind ourselves of Mr. Ohm's often forgotten formulas. There are two of 'em and they enable us to find out the combined impedance of speakers (or cabinets) when joined together in either Series or Parallel (note: if you don't know the difference between series and parallel in electrical terms, go look 'em up!) Let's
imagine that R1 is the impedance of our first speaker (or cabinet);
R2 in the impedance of the second one and R3 is the resulting impedance
when they are hooked-up together. Got that? Good Here are the two formulas:
The
Parallel formula is R3 = R1 X R2 &
the Series formula is R3 = R1 + R2
R1 + R2 So,
let's look at the Parallel law in action (if you need to also see an
example of addition in action, stop drinking and go to bed!). This is
the one you need to be most familiar with because although speakers
inside cabinets are often wired up in series, when it comes to hooking-up
cabinets to combos or heads it is ALWAYS done in parallel (well it is
in Marshall land and that's all we care about). The
most common question asked in stack world is, in my experience this,
"Hey dude, what impedance do I set my tube head to when I'm using
two cabs?" Well, let's take a look shall we… Let's
suppose that our pal has a DSL100 head and a 1960A and 1960B. Here's
an idiot proof hook-up list: 1.
Make sure both cabinets are switched to Mono operation. 2.
Make sure you have two SPEAKER cables to do the hook-up with
(NEVER use guitar cables).
(NOT the 4 Ohm input…remember, there are two 'cos of the stereo option). 4.
Plug one end of the other cable into the 16 Ohm MONO input of
the 1960B.
16 + 16 =
32 6.
Set the 4 Ohm/8 Ohm switch below the two parallel speaker outputs
on the back panel of our DSL100, plug the speaker cable ends into
said outputs…. 7. Switch the amp on, plug in yer axe, dial in a tone and rock!!
Whenever you're hooking-up two cabinets of the same exact impedance (and let's call that impedance "X") in parallel, the resulting impedance is X/2. So,
16 & 16 = 8; 8 & 8 = 4; 4 & 4 = 2, etc… Get
it? If not, try learning this phrase as it'll be very useful in your
next job: "would you like fries with that?!" |